Toshiba Satellite Pro M10 Series - Page 209

4 Replacement Procedures
Satellite Pro M10 Series Maintenance Manual (960-431) 4-ix
Figure 4-63 Disconnecting the FL tube ground wire ...................................................... 4-87
Figure 4-64 Removing the FL tube ................................................................................. 4-88
Figure 4-65 Removing the outside tape/cover tape ......................................................... 4-91
Figure 4-66 Removing the control PCB, top case and cover assembly .......................... 4-92
Figure 4-67 Removing the source PCB and gate PCB.................................................... 4-93
Figure 4-68 Removing the board assembly, tape pad sheet, light guide, cover bottom and
lamp assembly.............................................................................................. 4-95
Figure 4-69 Attaching the double tape, lamp assembly , cover bottom, sheets, light guide,
tape adhesive and board assembly ............................................................... 4-97
Figure 4-70 Attaching the source PCB and gate PCB..................................................... 4-98
Figure 4-71 Attaching the cover bottom, screw, top case, control PCB and FPC .......... 4-99
Figure 4-72 Attaching the outside tape and cover shield .............................................. 4-101
Figure 4-73 Removing the PCB cover........................................................................... 4-102
Figure 4-74 Removing the screws securing the PCB .................................................... 4-103
Figure 4-75 Removing screws securing the chassis ...................................................... 4-103
Figure 4-76 Removing the top chassis .......................................................................... 4-104
Figure 4-77 Removing the panel assembly ................................................................... 4-105
Figure 4-78 Removing one screw, two clips, tape and six sheets ................................. 4-106
Figure 4-79 Removing the lamp cover .......................................................................... 4-107
Figure 4-80 Freeing the HV cable ................................................................................. 4-108
Figure 4-81 Removing the FL assembly ....................................................................... 4-109
Figure 4-82 Disassembly of outside tape and cover shield ........................................... 4-111
Figure 4-83 Disassembly of Top case ........................................................................... 4-112
Figure 4-84 Disassembly of Source PCB and Gate PCB .............................................. 4-113
Figure 4-85 Disassembly of Board Ass’y, Tape Adhesive, Light guide, Cover Ass’y
bottom(L) ................................................................................................... 4-114
Figure 4-86 Assembly of Cover Ass’y bottom(L), Sheets, Light guide, Tape Adhesive and
Board Ass’y ............................................................................................... 4-115
Figure 4-87 Assembly of Source PCB and Gate PCB................................................... 4-116
Figure 4-88 Assembly of Cover Ass’y and Top Case ................................................... 4-117
Figure 4-89 Assembly of outside Tape and Cover shield ............................................. 4-118
Figure 4-90 Removing the tapes and film ..................................................................... 4-119
Figure 4-91 Removing the screws securing the X-PCB and metal frame..................... 4-120