OPERATOR’S MANUAL
series Robot Controller
Descriptions on display
[1] MODE: Indicates the currently selected master mode and run mode.
CONT : Continuous operation
CYCLE : Cycle operation
SEGMNT : Segment operation
[2] Right side on the 1st line: Displays active file name.
[3] L: No. of execution steps
[4] O: Speed override
[5] M: Machine status
FREE : Machine lock OFF status
[6] S: Execution status
RUN : A program is currently executed.
STOP RESET : A program is stopped in the initialize mode.
This is the same as the program reset.
STOP RETRY : A program is stopped in the restart mode.
It is restarted from the interrupted motion.
STOP CONT : A program is stopped in the continue mode.
It is restarted from the current program step.
[7] Bottom line: Function key menu display field
[SEL] : Selection of program to be executed
[MODE] : Run mode selection
[OVRD] : Override setting
[RESET] : Reset
[DO] : Direct execution
[WATCH] : Variable monitor
[STOP] : Stop
[BREAK] : Interruption
[LDISP] : Display of line to be executed
STE 80720
– 7-3 –
To Next Page
Loading...
Need help?
General
