Toshiba TS3100 - Selecting Run Mode [MODE]

OPERATOR’S MANUAL
series Robot Controller
7.3 Selecting Run Mode [MODE]
(1) Function
Changes over the run mode of automatic operation.
(2) Procedures
(a) Step 1: Command selection.
Press the NEXT key repeatedly until [MODE] is displayed in the menu.
Press the corresponding function key then.
M O D E : I N T E R N A L
/
C O N T T E S T P R O
L :
O : 1 0 0 %
M : F REE
S : S TOP
R E SET
S E L M O D E O V R D R E S E T >
(b) Step 2: Mode selection.
Select a desired run mode from the menu.
M O D E : I N T E R N A L
/
C O N T T E S T P R O
L :
O : 1 0 0 %
M : F REE
S : S TOP
R E SET
M O D E : C Y C L E
C O N T C Y C L E S E G
[CONT] : Repeats program execution continuously.
[CYCLE] : Stops program execution at the end of the program.
[SEG] : Stops program execution just before the next motion command.
STE 80720
– 7-6 –