OPERATOR’S MANUAL
series Robot Controller
(c) Step 3: Input through EXE key.
Make sure that your entry is correct, and press the EXE key. Then the
specified override value is shown under "O:" on the display.
M O D E : I N T E R N A L / C O N T T E S T P R O
L :
O : 90%
M : F REE
S : S TOP
R E SET
S E L M O D E O V R D R E S E T >
If zero (0) is specified for the speed override, a relevant message is displayed
and the entry becomes invalid.
(3) Caution
• The specified speed override is also operative in both the test operation
mode and external automatic mode. The selected override remains valid
until another override is specified.
STE 80720
– 7-9 –
To Next Page
Loading...
