TP-Link T2700G-28TQ - Show Memory-Utilization

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
170
Parameter
unitid —— Specify the unit in the stack whose CPU utilization information will be
displayed. If not specified, the CPU utilization information of all the switches in
the stack will be displayed.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the CPU utilization information of all the switches in the stack:
T2700G-28TQ#show cpu-utilization
show memory-utilization
Description
The show memory-utilization command is used to display the system’s
memory utilization in the last 5 seconds/1minute/5minutes.
Syntax
show memory-utilization [ unitid ]
Parameter
unitid —— Specify the unit in the stack whose memory utilization information will
be displayed. If not specified, the memory utilization information of all the
switches in the stack will be displayed.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the memory utilization information of all the switches in the stack:
T2700G-28TQ#show memory-utilization