TP-Link T2700G-28TQ - Ip Igmp Last-Member-Query-Count; Ip Igmp Last-Member-Query-Interval

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
313
Command Mode
Interface Configuration Mode
Example
Configure the IGMP version as version 3 on Interface VLAN 2:
T2700G-28TQ(config)# interface vlan 2
T2700G-28TQ(config-if)# ip igmp version 3
ip igmp last-member-query-count
Description
The ip igmp last-member-query-count command is used to configure the
number of Specific Query Messages that the switch sends on specified interface.
To restore to the default value on this interface, please use no ip igmp
last-member- query-count command.
Syntax
ip igmp last-member-query-count count
no ip igmp last-member-query-count
Parameter
count —— Specify the number of Specific Query Messages that the switch
sends, ranging from 1 to 20. The default value is 2.
Command Mode
Interface Configuration Mode
Example
Configure the number of Specific Query Messages that the switch sends as 3 on
Interface VLAN 2:
T2700G-28TQ(config)# interface vlan 2
T2700G-28TQ(config-if)# ip igmp last-member-query-count 3
ip igmp last-member-query-interval
Description
The ip igmp last-member-query-interval command is used to configure the
interval of Specific Query Messages that the switch sends on specified interface.