TP-Link T2700G-28TQ - Ip Rip Split-Horizon; Show Ip Rip

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
362
no ip rip poison-reverse
Command Mode
Interface Configuration Mode
Example
Enable poison reverse function on the interface VLAN2:
T2700G-28TQ(config)# interface vlan 2
T2700G-28TQ(config-if)# ip rip poison-reverse
ip rip split-horizon
Description
The ip rip split-horizon command is used to enable split horizon function on
the desired interface. To disable the split horizon function, please use no ip rip
split-horizon command.
Syntax
ip rip split-horizon
no ip rip split-horizon
Command Mode
Interface Configuration Mode
Example
Enable split horizon function on the interface VLAN2:
T2700G-28TQ(config)# interface vlan 2
T2700G-28TQ(config-if)# ip rip split-horizon
show ip rip
Description
The show ip rip command is used to display the RIP configurations.
Syntax
show ip rip [ interface | database [ specify ip-address mask ] ]