TP-Link T2700G-28TQ - Show Loopback-Detection Interface

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
202
T2700G-28TQ# show loopback-detection global
show loopback-detection interface
Description
The show loopback-detection interface command is used to display the
configuration of loopback detection function and the status of the specified
Ethernet port.
Syntax
show loopback-detection interface [ gigabitEthernet port ]
Parameter
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the configuration of loopback detection function and the status of all
ports:
T2700G-28TQ# show loopback-detection interface
Display the configuration of loopback detection function and the status of port 5:
T2700G-28TQ# show loopback-detection interface gigabitEthernet 1/0/5