TP-Link T2700G-28TQ - Passive-Interface; Ip Rip Receive Version

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
358
passive-interface
Description
The passive-interface command is used to suppress the sending of update
messages through the specified interface. To activate the interface, please use
no passive-interface command.
Syntax
passive-interface interface { interface-type } { interface-number }
no passive-interface interface { interface-type } { interface-number }
Parameter
interface-type ——Type of the interface, including fastEthernet, gigabitEthernet,
ten-gigabitEthernet, loopback and VLAN.
interface-number —— Number of the interface.
Command Mode
Router Configuration Mode (router rip)
Example
Suppress the sending of update messages through the interface VLAN 1:
T2700G-28TQ(config)# router rip
T2700G-28TQ(config-router)# passive-interface interface vlan 1
ip rip receive version
Description
The ip rip receive version command is used to specify the RIP receive version
on the desired interface. To return to the default configuration, please use no rip
receive version command. The interfaces use the global configuration
(configured with version command) before you specify its own RIP
send/receive version.
Syntax
ip rip receive version [1|2]
no ip rip receive version