TP-Link T2700G-28TQ - Chapter 26 Port Isolation Commands; port isolation

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
176
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Disable Gigabit Ethernet port 20:
T2700G-28TQ(config)#interface gigabitEthernet 1/0/20
T2700G-28TQ(config-if)#shutdown
flow-control
Description
The flow-control command is used to enable the flow-control function for a port.
To disable the flow-control function for this corresponding port, please use no
flow-control command. With the flow-control function enabled, the Ingress
Rate and Egress Rate can be synchronized to avoid packet loss in the network.
Syntax
flow-control
no flow-control
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the flow-control function for Gigabit Ethernet port 20:
T2700G-28TQ(config)#interface gigabitEthernet 1/0/20
T2700G-28TQ(config-if)#flow-control