TP-Link T2700G-28TQ - Show Ip Igmp Snooping

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
242
return to the default configuration, please use no ip igmp snooping querier
vlan command.
Syntax
ip igmp snooping querier vlan vlan-id {last-listener query-interval interval |
last-listener query-count count | special-query source-ip ip-addr }
no ip igmp snooping querier vlan vlan-id {last-listener query-interval |
last-listener query-count | special-query source-ip}
Parameter
vlan-id —— VLAN ID list, ranging from 1 to 4094.
interval—— The time interval of sending specific query frames by IGMP
Snooping Querier, ranging from 1 to 5 (Seconds). By default, it is 1. A specific
query will be sent on condition that “immediate-leave” is not enabled and a
leave frame is received.
count—— The times of sending specific query frames by IGMP Snooping
Querier, ranging from 1 to 5. By default, it is 2. The switch will still treat the port
as group member until the specific frames number sent by the querier reaches
“last-listener-query-count” and no report frame is received from the port.
ip-addr—— The source IP of the specific query frame sent by IGMP Snooping
Querier. It should not be a multicast IP or a broadcast IP. By default, it is
192.168.0.1.
Command Mode
Global Configuration Mode
Example
For VLAN 2, specify its last-listener-query-interval as 2:
T2700G-28TQ(config)#ip igmp snooping querier vlan 2 last-listener
query-interval 2
show ip igmp snooping
Description
The show ip igmp snooping command is used to display the global
configuration of IGMP Snooping.
Syntax
show ip igmp snooping