TP-Link T2700G-28TQ - Chapter 37 Proxy ARP Commands (License Required); Ip Proxy-Arp; Ip Proxy-Arp Enable Default-Route

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
310
Chapter 37 Proxy ARP Commands
(License Required)
The switch uses Proxy ARP to help hosts learn MAC addresses of hosts on other networks or
subnets.
ip proxy-arp
Description
The ip proxy-arp command is used to enable Proxy ARP function on the
specified VLAN interface or routed port. To disable IGMP function on this
interface, please use no ip proxy-arp command.
Syntax
ip ip proxy-arp
no ip proxy-arp
Command Mode
Interface Configuration Mode
Example
Enable the Proxy ARP function on Interface VLAN 2:
T2700G-28TQ(config)# interface vlan 2
T2700G-28TQ(config-if)# ip proxy-arp
Enable the Proxy ARP function on routed port 1/0/2:
T2700G-28TQ(config)# interface gigabitEthernet 2
T2700G-28TQ(config-if)# no switchport
T2700G-28TQ(config-if)# ip proxy-arp
ip proxy-arp enable default-route
Description
The ip proxy-arp enable default-route command is used to enable the
default-route-searching function when searching for the ARP proxy. To disable
the default-route-checking function, please use no ip proxy-arp enable
default-route command.