JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
20
Mode Accessing Path Prompt
next mode
Interface
Configuration
Mode
Layer 2 Interface:
Use the interface
gigabitEthernet port or
interface range
gigabitEthernet port-list
command t
mode.
T2700G-28TQ(config-if)#
T2700G-28TQ(config-if- range)#
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global Configuration
mode.
A port number must be
specified in the interface
command.
Layer 3 Interface:
Use the
command to enter Routed Port
Configuration mode.
Use the interface vlan vlan-id
command to enter VLAN
Interface mode from Global
Configuration mode.
Use the interface loopback id
command to enter Loopback
Configuration mode.
T2700G-28TQ(config-if)#
T2700G-28TQ(config-if-
range)#
Use the end
Privileged EXEC mode.
Enter the exit or the
#
command to return to
Global Configuration
mode.
DHCP
Configuration
Mode
Use the
command to enter
DHCP Configuration Mode
mode.
T2700-28TQ(config-dhcp)
Use the end
Privileged EXEC mode.
Enter the exit or the
#
command to return to
Global Configuration
mode.
MST
Configuration
Mode
Use the spanning-
and to
enter this mode from Global
Configuration mode.
T2700G-28TQ(config- mst)#
Use the end
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
Global configuration mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and the
switch is established by a console port or by a telnet connection.
2. Each command mode has its own set of specific commands. To configure some commands,
you should access the corresponding command mode firstly.
Global Configuration Mode: In this mode, global commands are provided, such as the
Spanning Tree, Schedule Mode and so on.
To Next Page
Loading...
