61
You can also keep the default WPS Status as Enabled and click the Add device button in Figure
4-45, then Choose “Press the button of the new device in two minutes” and click Connect.
(Shown below)
Figure 4-46
Step 2: Press and hold the WPS button of the client device directly.
Step 3: The WPS LED flashes for two minutes during the WPS process.
Step 4: When the WPS LED is on, the client device has successfully connected to the modem
router.
Refer back to your client device or its documentation for further instructions.
II. Enter the client device’s PIN on the modem router
Use this method if your client device has a WPS PIN number.
Step 1: Keep the default WPS Status as Enabled and click the Add device button in Figure
4-45, then the following screen will appear.
To Next Page
Loading...
