Figure 4-44
You can enable or disable Guest Network. When you enable this function, you could set wireless
parameters for Guest Network.
SSID: The guest network name. When setting up a Guest network, it is strongly
recommended to use a name that easily distinguishes it from your primary network. The
default name is TP-LINK_Guest_xxxxxx (xxxxxx is the last six numbers of MAC address).
Security: The default value is disabled, but it’s strongly recommended to enable
WPA/WPA2-Personal. WPA/WPA2-Personal is the WPA/WPA2 authentication type based
on pre-shared passphrase.
Authentication Type: Select the Authentication Type from the drop-down list, the default
method is Auto, and you can leave it as a default setting.
Encryption: You can select either Auto, or TKIP or AES.
Wireless Password: You can enter ASCII characters between 8 and 63 characters or 8 to
64 Hexadecimal characters.
Group Key Update Period: Specify the group key update interval in seconds. The value
should be 30 or above. Enter 0 to disable the update.
Allow Guests to access my Local Network: The guests have access to your Local
Network, but can not login the GPON router’s web management interface.
Allow Guests to access my USB Storage Sharing: The guests can access the specified
files on the USB storage device via the function of USB Storage Sharing, but the function of
FTP Server, Media Server and Print Server are not available in Guest Network. For more
details please refer to 4.9.3 Storage Sharing
.
Guest Network Isolation: This function can isolate wireless clients on your guest network
from each other. Client isolation is disabled by default.
Guest Network Bandwidth Control: With this function, you can configure the Upstream
Bandwidth and Downstream Bandwidth for guest network.
Click Save to save your settings.
54
To Next Page
Loading...
