Note:
RIP cannot be configured on the WAN Interface which has NAT enabled (such as PPPoE).
4.11 IPv6 Route Settings
Choose “IPV6 Route Settings”, it includes three menus: IPv6 Default Gateway, IPv6 Static
Route. The detailed descriptions are provided below.
4.11.1 IPv6 Default Gateway
Choose “IPv6 Route Settings”“IPv6 Default Gateway”, you can see the IPv6 Default Gateway
screen. You can select a WAN Interface from the drop-down list as the system default gateway.
Figure 4-80
Click the Add Interface button, you can add WAN Interfaces.
Click the Save button to save your settings.
4.11.2 IPv6 Static Route
Choose “IPv6 Route Settings”
“IPv6 Static Route”. You can see the IPv6 Static Route screen,
this screen allows you to configure the static routes (shown in
Figure 4-81). A static route is a
pre-determined path that network information must travel to reach a specific host or network.
Figure 4-81
To add IPv6 static routing entries:
79
To Next Page
Loading...
