Refer back to your client device or its documentation for further instructions.
II. Enter the client device’s PIN on the GPON router
Use this method if your client device has a Wi-Fi Protected Setup PIN number.
Step 1: Keep the default WPS Status as Enabled and click the Add device button in Figure 4-34,
then the following screen will appear.
Figure 4-36
Step 2: Enter the PIN number from the client device in the field on the above WPS screen. Then
click Connect button.
Step 3: “Connect successfully” will appear on the screen of Figure 4-36, which means the client
device has successfully connected to the GPON router.
III. Enter the GPON router’s PIN on your client device
Use this method if your client device asks for the GPON router’s PIN number.
Step 1: On the client device, enter the PIN number listed on the GPON router’s Wi-Fi Protected
Setup screen. (It is also labeled on the bottom of the GPON router.)
Step 2: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected
Setup process.
Step 3: When the WPS LED is on, the client device has successfully connected to the GPON
router.
Step 4: Refer back to your client device or its documentation for further instructions.
Note:
1) The WPS LED on the GPON router will light green for five minutes if the device has been
successfully added to the network.
2) The WPS function cannot be configured if the Wireless Function of the GPON router is
disabled. Please make sure the Wireless Function is enabled before configuring the WPS.
4.6.3 Wireless Security
Choose menu “Wireless”” Wireless Security”, you can configure the security settings of your
wireless network.
There are three wireless security modes supported by the GPON router: WEP (Wired Equivalent
Privacy), WPA-PSK (Pre-Shared Key), WPA2-PSK (Pre-Shared Key).
46
To Next Page
Loading...
