31
General Information
If the traction control light and the
malfunction indicator light (MIL) become
illuminated at the same time, there is a
malfunction with the traction control system
which requires investigation by your local
Triumph dealer.
Cruise Control Light
Cruise control (see page 56) can
only be activated when the
motorcycle is travelling at a speed
between 30 to 100 mph (48 to
16 0 k m / h ) a n d i s i n 4
th
gear or higher. When
activated, the cruise control light in the
instruments will be illuminated, and the set
speed will be displayed in the lower message
area.
1. Cruise control light
2. Instrument message
If the traction control is not functioning,
care must be taken when accelerating and
cornering on wet/slippery road surfaces to
avoid rear wheel spin. Do not continue to
ride for longer than is necessary with the
MIL and traction control lights illuminated.
Contact an authorised Triumph dealer as
soon as possible to have the fault checked.
Hard acceleration and cornering in this
situation may cause the rear wheel to spin
resulting in loss of motorcycle control and
an accident.
Cruise control must only be used where
you can ride safely at a steady speed.
Cruise control should not be used when
riding in heavy traffic, on roads with
sharp/blind bends or when roads are
slippery.
Using cruise control in heavy traffic, on
roads with sharp/blind bends or when
roads are slippery, may result in loss of
motorcycle control and an accident.
TRIP 1
MPH
60
10:08
6
22
1892
ODO
144.2
To Next Page
Loading...
