64
General Information
Headlight Dip Switch
High or low beam can be selected with the
headlight dip switch. To select high beam,
push the switch forward. To select low beam,
push the switch rearwards. When the high
beam is turned on, the high beam indicator
light will illuminate.
Note:
• A lighting on/off switch is not fitted
to this model. The position light, rear
light and licence plate light all
function automatically when the
ignition is turned to the ON position.
• The headlight will only function
when the ignition switch is turned to
the ON position and the engine is
running.
An alternate way to turn on the
headlight, without the engine
running, is to pull in the clutch lever
then turn the ignition to the ON
position. The headlight will be on
and remain on when the clutch lever
is released.
The headlight will go off while
pressing the starter button until the
engine starts.
Direction Indicator Switch
When the indicator switch is pushed to the
left or right and released, the corresponding
direction indicators will flash on and off.
The indicator self cancel system becomes
active eight seconds after operating a
direction indicator. Eight seconds after
turning the direction indicator on and after
riding a further 65 metres, the indicator self
cancel system will automatically turn off the
indicators. The indicators can be cancelled
manually.
To manually turn off the indicators, press and
release the indicator switch in the central
position.
To disable the indicator self cancel system,
see page 49.
Horn Button
When the horn button is pushed, with the
ignition switch turned to the ON position, the
horn will sound.
To Next Page
Loading...
