59
General Information
Increasing Speed while in Cruise
Control
To increase the speed, press and release the
RES/+ end of the adjust button. Each press of
the button will increase the speed by 1 mph
or 1 km/h. If the button is held, the speed will
continuously increase in single digit
increments. When the desired speed is
shown in the display, stop pressing the adjust
button.
While increasing the speed, the display
screen in the instruments will show the new
set speed in the lower display area. The new
speed will flash until the motorcycle has
achieved that speed.
After 4 seconds the display screen will
change to the previous display.
Note:
• If riding up a steep incline and cruise
control is unable to maintain the set
speed, the instruments will show the
set speed flashing until the
motorcycle has regained the speed.
An alternative way to increase the speed in
cruise control is to accelerate to the desired
speed using the throttle grip and then press
the SET/- end of the adjust button.
Decreasing Speed while in Cruise
Control
To decrease speed, press and release the
SET/- end of the adjust button. Each press of
the button will decrease the speed by 1 mph
or 1 km/h. If the button is held, the speed will
continuously decrease in single digit
increments.
While decreasing the speed, the display
screen in the instruments will show the new
set speed.
When the desired speed has been achieved,
stop pressing the adjust button. After
4 seconds the display screen will change to
the previous display.
To Next Page
Loading...
