54
General Information
Triumph Electronic
Suspension (TES) (if fitted)
The Triumph Electronic Suspension (TES)
system controls adjustment of the front and
rear suspension damping and rear
suspension pre-load settings.
TES allows a convenient remote adjustment
of the riding MODE (damping settings) and
LOADING (pre-load settings) via the
instruments while the motorcycle is stationary
(MODE and LOADING settings) or moving
(MODE only).
The three MODE (damping) options
available are:
•COMFORT;
•NORMAL;
•SPORT.
The three LOADING (pre-load) options
available are:
•1UP;
•1UP+LUGGAGE;
•2UP.
To access the TES settings, see
ADJUSTMENT on page 42.
Once a mode or loading adjustment has
been selected, and the engine is running, the
suspension will start to adjust, the TES
warning light will flash once every second
and the lower message area will display the
message PLEASE WAIT - TES SYSTEM
ADJUSTMENT IN PROGRESS, until the
system has finished adjusting.
TES Adjustment in Progress
Once adjustment is complete the message
TES SYSTEM ADJUSTMENT COMPLETE
will be displayed and the warning light will go
out.
Adjustment Complete
After adjusting the suspension, operate the
motorcycle in an area free from traffic to
gain familiarity with the new settings. Do
not loan your motorcycle to anyone as they
may change the suspension settings from
the one you are familiar with causing loss
of control or an accident.
To Next Page
Loading...
