55
General Information
If the engine is not running when a profile is
loaded, or the ADJUSTMENT menu is used
to change the MODE or LOADING settings,
the request to change the settings will be
saved.
Once the engine has started, the adjustment
will be made as described above.
If the engine is not started before the ignition
is switched off then the requested setting will
be lost and the previous settings will be used.
It is also possible to store the TES settings to
two separate profiles (see page 41 ), allowing
settings to be stored for different rider’s
individual preferences, different riding styles
or different loading conditions.
System Calibration
The system will re-calibrate the damper
adjustment motors each time the ignition is
turned on, and the pre-load adjustment
motor after every 20 ignition on cycles.
Damper adjustment motor calibration takes
approximately 2 - 3 seconds, and pre-load
motor calibration takes around
20 - 30 seconds.
The warning light will flash twice every
second during system re-calibration, and the
message PLEASE WAIT - CALIBRATING
(accompanied by a 'wait' icon) will appear in
the lower message screen.
TES Calibration
During re-calibration the motorcycle must
remain stationary. Riding the motorcycle will
cause the re-calibration to be halted and the
warning light to remain lit.
To Next Page
Loading...
