88
General Information
2. Insert the key into the lock. Turn the key
to the RELEASE position and lift the
carrying handle to its fully raised position.
1. Key slot (shown in LOCK position)
2. Lock position symbol
3. Unlock position symbol
4. Release position symbol
3. Position the top box such that the
mounting slots on the bottom of the top
box locate with the mounting hooks on
the sliding carriage.
1. Mounting slots
2. Mounting hooks
4. Lower the top box until it sits flat on the
sliding carriage then push forwards to
fully engage its mountings.
5. Lock the top box to the sliding carriage
by turning the key to the RELEASE
position, put the carrying handle to the
fully closed position then turn the key to
the LOCK position. An audible click can
be heard when the carrying handle is put
into the fully closed position and the top
box is correctly latched to the sliding
carriage.
If an audible click cannot be heard when
the carrying handle is put into the fully
closed position, the top box may not be
correctly latched to the sliding carriage.
1. L o c k
2. Carrying handle in the fully closed
position
To Next Page
Loading...
