Trotec Speedy 360 flexx Operation Manual

Speedy 360
BA 8032_2.2_EN (05/2016) 66 / 90
www.troteclaser.com
8.7.2.1 Software focus (flexx lens)
Using a flexx lens the focus point differs depending on the laser source.
When carrying out a software focus, JobControl
®
is going to switch to the right laser source and
adjusts the focus point difference automatically as soon the lens type and processing type per laser
source get entered into the material database in JobControl
®
. Manually switching the laser source is
therefore not necessary.
Whenever the flexx lens and a CO
2
laser source processing type gets selected, the table will drive
down automatically according the “standard” focus procedure.

Trotec Speedy 360 flexx Specifications

General

Brand	Trotec
Model	Speedy 360 flexx
Category	Printer
Language	English