Trotec Speedy 360 flexx Operation Manual

Speedy 360
BA 8032_2.2_EN (05/2016) 82 / 90
www.troteclaser.com
Problem
Possible Cause
Resolution
Fine details on stamps are
engraved too thinly
 Too steep shoulders
 Choose other shoulder or edit
(flat/medium/steep):
Options/Process
Options/Stamp
The size to be engraved or
cut does not match the size
in Corel Draw
 Raster correction ON in
JobControl
®
 Wrong size settings in the
printer driver
 Wrong image position is
selected in the layout tab
(printing)
 Wrong machine is selected
in the JobControl
®
 Switch off raster correction in
JobControl
®
(settings/advanced
options/laser tab)
 Use the same size as in
Corel draw
 Switch the layout settings to:
as in document
 Select the proper machine in
JobControl
®
Corners and angles are not
cut or marked
 Power too low
 Increase the correction in
JobControl
®
(Settings /
Material Templates Setup—
Correction)
No referencing after
startup
 Top, front or side door not
closed
 Close doors
No response upon
switching on of the system
 Fuse blown
 No electric power at power
outlet
 Check fuses
 Check power outlet
No communication with
machine
 Invalid COM port selection
 Communication cable defect
 COM: port is in use by
another program
 Change selection
 Check cable
 Close this program, or
change the COM port
Connection to machine
frequently interrupted
 Electromagnetic emissions
 Make sure that machine and
computer are connected to
the same electric circuit;
the original cable lengths
should not be exceeded

Trotec Speedy 360 flexx Specifications

General

Brand	Trotec
Model	Speedy 360 flexx
Category	Printer
Language	English