EasyManuals Logo

Tyco Galaxy SC Controller User Manual

Tyco Galaxy SC Controller
413 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #306 background imageLoading...
Page #306 background image
Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 Troubleshooting 8 - 5
2. Open the File menu and select Backup. Select a filename and
directory to store the system configuration. Click OK. EasyView
displays the status of the backup. Click OK when the Backup
operation is completed.
3. Open the Options menu and select Setup Sites. Select your
connection profile from the Site list. Click Modify. Change the
Administrator password to the default password administrator.
Change the Connect password to administrator. Click OK. Click
Close.
4. Open the Connect menu and select Disconnect to end the
EasyView session.
Replace Battery You must remove the BJH Intelligent Controller circuit pack to replace
the battery. Follow these steps:
1. Identify the BJJ Intelligent Power board (far left position) and pull
its circuit pack locking lever forward and downward to release it
from the backplane. Slide the pack straight out until fully
disengaged from the backplane.
2. Identify the BJH Intelligent Controller circuit pack and pull its
locking lever forward and downward to unlock the pack. Then
slide the pack straight out of the card cage.
3. Remove the memory battery. Take care not to flex the battery
holder clip excessively.
4. Insert the memory battery (Panasonic BR2032 or equivalent, Tyco
Comcode 406526079) into the BJH (Intelligent Controller) circuit
pack X201 battery holder. Observe proper polarity; the battery
holder clip contacts the + side of the memory battery. Take care
not to flex the battery holder clip excessively.
5. Align the BJH Intelligent Controller circuit pack with the circuit
pack tracks and carefully slide the circuit pack into the card cage.
Seat and lock the circuit pack into the card cage by lifting the
circuit pack locking lever to the full upright position.
6. Reengage the BJJ Intelligent power board into the backplane and
lift its circuit pack locking lever into the full upright position.
Observe active green LEDs on all packs after approximately one
minute.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tyco Galaxy SC Controller and is the answer not in the manual?

Tyco Galaxy SC Controller Specifications

General IconGeneral
BrandTyco
ModelGalaxy SC Controller
CategoryController
LanguageEnglish

Related product manuals