Tyco Electronics Galaxy SC Controller J85501F-1
7 - 15 Feature Descriptions Issue 13 February 2001
To return to float mode, use the following command:
OPE DCP,STT=FLOAT
To view the boost or BTP history, issue the following command:
HIS BST
To clear the boost or BTP history, issue the following command:
CLH BST
Call-Out The call out feature allows the user to program the Galaxy SC to call-out
via the modem port when an alarm occurs or retires. The user can
configure up to 4 phone numbers for call-out and an alternate number to
call if any of the others fail to connect. In addition, each alarm can be
configured to call-out only if the alarm remains active for a
programmable amount of time and to call-out periodically while the
alarm condition persists.
Call-out Phone
Number
Configuration
Parameters
There are five call-out phone numbers in the system identified as P1, P2,
P3, P4, and A1. The A1 phone number is an alternate phone number that
is called in the event that any of the other numbers fail to connect.
Call-out phone number configuration involves defining a phone number
and setting the communication parameters to be used when that phone
number is called. For each call-out phone number, including the
alternate phone number, the following parameters may be configured:
Type Range: Data or Pager
Phone Number (up to 25 characters)Default: none
valid characters: 0-9 ( ) - # * ,
(, translates to a 2 second delay)
Connect Baudrate- Range: 300, 1200, 2400, 4800, 9600,
14400 default: 2400
Data Bits Range: 7 or 8 default: 8
Parity- Range: odd, even, none default: none
Stop Bits- Range: 1 or 2, default: 1
Pager ID Delay Range: 0 to 9 seconds, default: 0
Pager ID (up to 25 characters) Default: none
To Next Page
Loading...
Need help?
General
