Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 Troubleshooting 8 - 15
PFD1 Password At Default
One or more of the log-in passwords is at it’s
default value. All passwords must be set to
something other than their default before this
event will clear.
PGI1 Program Line Invalid
The program line for a derived channel, user
defined event channel, or RPM control relay
channel contains an invalid operand. Typically
occurs when a RPM channel value or state is used
in a program line and that RPM is disconnected or
otherwise goes into a failure mode.
PHA1 Phase Or Low Output
A connected 3-phase rectifier is indicating loss or
low voltage of an AC input phase.
J874-series Tyco rectifiers can produce partial
output with the loss of an AC input phase, so a
PHA1 against this rectifier type in an intelligent
Galaxy results in their placement into a TR
standby mode until 10AM the following day or
until a BD alarm activates.
PHT1 Processor Halt
Galaxy’s BJH or Millennium’s BSJ intelligent
controller stopped processing, usually due to a
reset or reboot.
POR1 Number Did Not Respond
Active when the periodic status call-out phone
number failed to connect 4 times in a row. This is
a latched event, remaining active until cleared by
a user.
RBF1 Regulation Battery Fuse
Operated Regulation fuse, A1 to C8, on Galaxy’s
BJF fuse card.
RFA1 Rectifier Fail
A connected rectifier is reporting a failure
condition to Galaxy.
RIC1 Rectifier Incomplete Config
The controller recognizes the presence of a
rectifier for which sufficient configuration has not
been completed.
RPF1 Remote Peripheral Fuse
Operated PER MON fuse on Galaxy’s BJF fuse
card or Option Power fuse on Millennium’s BSH
basic card.
Table 8-A: Galaxy Alarms
Symbol Designation Explanation
To Next Page
Loading...
Need help?
General
