Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 Installation 3 - 1
3 Installation
Overview The Galaxy SC Controller can be installed as part of a new plant or can
replace the controller of an existing plant. This chapter is broken down
into four sections:
• New Plant Installation
• MCS Controller Replacement
(The replacement of other plant controllers can be adapted from
this MCS replacement section.)
• Installation of Optional Features in the Galaxy SC
• Wiring Options
• Procedures for the Addition, Replacement, and Removal of Circuit
Packs
Precautions • Always consider personal safety before beginning any procedure.
• Be aware of the presence of unfused battery potential in the vicinity
of the controller.
• Use only approved, properly insulated tools.
• Observe proper grounding and ESD (Electrostatic Discharge)
procedures.
Tools • Standard power installation tool set (insulated).
• Crimping equipment for 12 to 22 AWG.
• Digital voltmeter accurate to 2 decimal places.
To Next Page
Loading...
