Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
Appendix D - 18 TL1 (Transaction Language 1) and X.25 Interface Issue 13 February 2001
Login by OS: The OS should login to the Galaxy using the
“ACTIVATE USER” TL1 command. After successful login by OS, the
Galaxy is ready to respond to other TL1 commands and send
autonomous TL1 messages to OS.
TL1 Commands
Supported by
Galaxy
List of Supported Commands
Activate User
Cancel User
Retrieve Header
Retrieve Alarm
Retrieve Equipment
Report Alarm
Retrieve Alarm Environment
Set Alarm Cutoff
Operate Alarm Cutoff
Report Alarm Environment
Report Removal
Report Restoration
Read Memory
Write Memory
Details of Supported Commands:
TL1 specifications spell out the spacing and syntax of TL1 responses.
To specifically show TL1 format in this text, the following conventions
will be used:
cr Carriage return
lf Line feed
^ Space<R>
; Enters commands
Response Header:
The response header is attached to the beginning of all messages sent by
the Galaxy.
cr lf lf
^^^source id^yy-mm-dd^hh:mm:ss cr lf
where:
source id system id (15 characters) of the Galaxy as displayed in system
header.

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English