Tyco Electronics Galaxy SC Controller J85501F-1
3 - 36 Installation Issue 13 February 2001
Galaxy Option
Features
The following Galaxy optional features require the addition of external
equipment or wiring. Install them as described below.
Intelligent
Controller
(J85501F1 L- AB
or AC)
The Intelligent Controller Option is required for any of the more
advanced Galaxy features to function. This option provides both the
microprocessor and the power for the Intelligent side of the Galaxy
controller. No communication with the Galaxy except through the front
display panel can be completed if this option is not equipped.
These items are included with the Intelligent Controller option:
• BJH Intelligent Control Board
• BJJ Intelligent Power Board
• Aux Port Cable Interface Card
• EasyView Software and Product Manual
1. Mount the Aux Port Cable Interface Card on backplane connector
P100 and secure with the mounting screw provided on the card.
Refer to Figure 2-2 for backplane mounting locations. This
interface board contains RS485 and RS232 connectors which are
identified as the “Aux” port for remote communication with
Galaxy. Only the RS485 or RS232 connector can be activated for
use at one time, selected by the positioning of BJH SW203-1 and
SW203-5. See Table 3-D. Complete the wiring for the RS232 or
RS485 connector in accordance with Figure 3-7.
2. Refer to Section 3, Circuit Pack Addition/Removal/Replacement,
for information on adding the BJH and BJJ packs into their
assigned slots in the Intelligent half of the Galaxy card cage.
3. Refer to the EasyView Product Manual for instructions on its use
of the EasyView graphical interface software.
To Next Page
Loading...
Need help?
General
