Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
3 - 38 Installation Issue 13 February 2001
Modem (J85501F1
L-AE)
The Modem option permits communication over the public network
analog lines at baud rates of up to 19200. This option is necessary for
Call Out on Alarm and to enable the Data Switch option to access the
public network.
Included with the Modem option are the following:
• BJL Modem Board
• Modem Port Cable Interface Card
1. Mount the Modem Port Cable Interface Card on backplane
Connector P101 and secure with the mounting screw provided on
the card. Refer to Figure 2-2 for backplane mounting locations.
This Interface board contains 2 RJ11 telephone line jacks, J111 &
J112. Connect J112 to the incoming analog phone line and use
J111 if desired to extend this line on to another phone or device.
(J111 & J112 are connected in parallel internally. The use of
another phone or device on the same line as Galaxy may cause a
“No Dial Tone Detected” warning should Galaxy attempt to call
out while the line is in use.)
2. Set BJH or BJJ SW203-3 and SW203-4 as desired to define the
type of access to be allowed via the Modem port. See Table 3-D.
3. The BJL Modem board can only be located in Option slot 1 in the
Intelligent side of the Galaxy card cage. See Figure 3-1. Refer to
Section 3, Circuit Pack Addition/Removal/Replacement, for
information on adding the BJL pack into its assigned slot.
Data Switch
(J85501F1 L-AH)
The Data Switch option allows Galaxy to interface with up to four
additional RS232 devices such as MCS, ECS, XCS and other Galaxy
controllers and RAS and OMNIpulse remote monitor and control units.
When used with the BJL Modem option, the Galaxy and the four Data
Switch ports can all be accessed over a single phone line and Galaxy will
control Call Out on Alarm for all of the connected devices.
Included with the Data Switch option are the following:
• BJK Data Switch Board
• Data Switch Port Cable Interface Card
• Four 9 pin TC5232 Cable Assemblies
1. Mount the Data Switch Port Cable Interface Card on the
backplane Connector corresponding to the Intelligent side optional

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English