SAFETY DECALS
The following safety decals ARE INSTALLED ON THE MACHINE.
If a decal become damaged,illegible or is on the machine,replace it.The decal part number is listed in
the parts lists.
●
●●
● Before starting and operating know the
operating and safety instructions in the
operators Manual and on the tractor.
● Clear the area of bystanders.
● Locate and know operation of controls.
● Start engine only from Operator’s seat
with depressed clutch pedal,
transmission in the neutral, PTO disengaged
and hydraulic control in lower position
● Do not permit anyone but the operator to
ride on the tractor.
There is no safe place for rider.
● Lock brakes together, use warning lights
and SMV emblem while driving on roads.
● Lower equipment, place gear shift levers
in neutral, stop engine, remove the key
and apply parking brake before leaving
the tractor seat.
● Air pressures are specified by the
manufacturer.
WARNING
● Slow down on turns, rough ground and
slopes to avoid upset.
FAILURE TO FOLLOW ANY OF THE INSTRUCTIONS ABOVE CAN CAUSE SERIOUS
INJURY TO THE OPERATOR.
Location: On FENDER LH
Part No.: 1260-904-070-1A
TO AVOID POSSIBLE PERSONAL INJURY,
THIS GUARD MUST BE KEPT IN PLACE
Location: ON PTO guard
Part No.: 1260-904-069-0A
1-11
WARNING
Location: On Dash cover side RH
Part No.: 1260-904-064-0
CAUTION
TO PROTECT ENGINE AND
HYDRAULIC COMPONENTS.
● Idle Engine for 1 minute before
shut down or full load operation.
● Do not exceed 1/2 throttle for
first 5 minutes of operation
To Next Page
Loading...
