TYM T303HST User Manual

STEP 17. (Test)
a.Lift OSPM out of the tool and prepare it for
testing.
The pressure relief valve can be set either on a
test panel or in a system with pressure-gauge
read-off.
b.Insert plastic plug.
STEP 18.
Dust seal (1)
Guide the dust seal ring down over the shaft
end press into place in the housing with
assembly tool. SJ 150L0396 - 01.
Note: The dust seal must be fitted after testing
so that any leakage from the shaft seal can be
detected.
8-11

TYM T303HST Specifications

General

Brand	TYM
Model	T303HST
Category	Tractor
Language	English