Unify OpenScape 4000/HiPath 4000 - Programmable Sensor Keys

Getting to know your OpenStage phone 17
Programmable sensor keys
Your OpenStage 40 T has six illuminated sensor keys to which you can assign functions or num-
bers.
Depending on how they are programmed, you can use the sensor keys as:
• Function keys  page 67
• Repdial/Direct station selection key
 page 68
Touch the key to activate the programmed function or dial the stored number.
Press the key to open a menu for programming it  page 67.
A label for the function is displayed to the left of the key; it cannot be changed. You can define the
labeling for repdial or DSS keys according to your requirements
 page 70.
The status of a function is shown by the LED on the corresponding sensor key.
Meaning of LED displays on function keys
Increase the number of programmable sensor keys by connecting a key module  page 14.
Only for repdial keys can you also program the second level for direct destination selection.
The configuration of direct station selection keys must be activated by your administrator.
Direct station selection keys can be assigned an internal number from the HiPath 4000 net-
work.
A typical application of direct station selection keys is the executive-secretary configuration
 page 96.
LED Meaning of function key
S
Off The function is deactivated.
T
Flashing
1
1 In this manual, flashing sensor keys are identified by this icon, regardless of the flashing interval. The flashing interval
represents different statuses, which are described in detail in the corresponding sections of the manual.
The function is in use.
R
On The function is activated.
The programmable sensor keys on multi-line phones function as line keys  page 82.
Mirea, Ch
Shift