Unify OpenScape 4000/HiPath 4000 - Variable call forwarding (all calls); Configuring and activating variable call forwarding

Basic functions 37
Variable call forwarding (all calls)
In the case of variable call forwarding, programming a forwarding destination ac-
tivates call forwarding for all calls. If call forwarding is deactivated, the forward-
ing destination is deleted at the same time.
Configuring and activating variable call forwarding
c Open the idle menu  page 21.
Select and confirm the option shown.
or
N Open the Program/Service menu  page 26.
Confirm the option shown.
Confirm the option shown.
"Variable call forw." is displayed.
Select and confirm the option shown.
j Enter the phone number of the call forwarding destination.
Confirm, when the phone number is complete.
Call forwarding is saved and activated.
Deactivating variable call forwarding
r Press the lit key. The LED goes out.
or
c Open the idle menu  page 21.
Select and confirm the option shown.
Call forwarding is deactivated. The destination number is deleted.
Act. FWD-VAR-ALL-BOTH?
Destinations? g
Call forwarding? g
Enter destination:
Save?
If you enter a cross-system number, you must complete your entry by
pressing
(.
Deact call forwarding?