Unify OpenScape 4000/HiPath 4000 - Configuring repdial;direct station selection keys

68 Programming sensor keys
Configuring repdial/direct station selection
keys
Direct station selection keys can be assigned an internal number from the
HiPath
4000 network.
A typical application of direct station selection keys is the executive-secretary
configuration
 page 96.
You can program repdial keys with external phone numbers on two levels. To
program the second level, you must configure a "Shift" key
 page 67.
See also  page 17.
Prerequisite: You have programmed a sensor key with the function "Repdial"
or "Direct station select"
 page 67.
N Open the Program/Service menu  page 26.
Confirm the option shown.
Select and confirm the option shown.
or
Select and confirm the option shown.
Press the configured repdial key,
or
Press the configured direct station select key.
Defining the phone number
j Enter the number
Confirm the option shown.
Confirm the option shown. Your entry is saved.
Your telephone can be configured so that direct station selection keys can-
not be set up, thus facilitating data and personal security. Contact your ad-
ministrator should you have questions.
Destinations? g
Repdial?
Direct Station Select?
R
DSS
Enter new number?
Completed?