Unify OpenScape 4000/HiPath 4000 - Forwarding Calls on Lines; Ring Transfer

Making calls via multiple lines 95
Forwarding calls on lines
When you activate call forwarding for a shared line ( page 83), the line is gen-
erally also forwarded to other phones.
The process for configuring call forwarding for a specific line is identical to the
call forwarding process already described. You must simply ensure that the re
-
quired line is already seized.
S Press the line key for the required line. The LED lights up.
Please read the additional notes on  page 35.
Ring transfer
If you temporarily leave your workstation or do not wish to be disturbed, you can
transfer incoming calls to your line to another destination. A "RTRLN" (ring trans
-
fer/line) sensor key can be programmed for each line.
Activating
S Press the "RTRLN" programmed sensor key. The LEDs on your phone and on
the destination phone light up. When you receive a call, the line key flashes but
the phone does not ring. The call is signaled on all other team phones.
Deactivating
R Press the "RTRLN" programmed sensor key. The LED goes out. Calls are sig-
naled on the phone once more.