Unify OpenScape CP400 - Speaker call to a target destination; Speaker call to a variable target

120 Other settings and functions
Speaker call to a target destination
The system code for “Voice call group participants“ and the speed dial number
for the corresponding group member are programmed on a destination dial key
 page 80.
Press programmed dial key. It will immediately establish a connection with the
destination’s loudspeaker.
^ The receiver can establish the connection by picking up the handset.
: When the receiver the loudspeaker key
or
presses the line key (if set-up), the connection is cancelled.
Speaker call to a variable target
When talking in a group, the loudspeaker and microphone on the target phone
are automatically turned on.
^ Lift the handset.
or
: Press the key and use speakerphone mode.
j System code for “Speaker call“ (ask relevant administrator if necessary)
or
Press programmed key for “Speaker call“.
j Enter the speed dial code for the corresponding group member.
Loudspeaker and microphone of the target phone are automatically turned on.
Speaker call to a target destination
The system code for "Speaker call" and the speed dial number for the corres-
ponding group member are programmed on a destination dial key  page 64.
Press programmed key.
Loudspeaker and microphone of the target phone are automatically turned on.
123456
_
Line 1
_
Speaker call
_
DSS
_