UPONOR CONTROL SYSTEM WIRED - INSTALLATION AND OPERATION MANUAL
23
7 Finishing installation
Make a complete check up of the installation:
1. Check that the thermostats are working correctly.
Turn thermostat setpoints to maximum to obtain a heating
demand and make sure that the actuators are running.
2. Reset the thermostats to the defined operating settings.
3. Close the covers of the controller and the thermostats.
4. Fill in the “Installation report” on the centre pages of
booklet.
5. Give the manual and all information about the system to the
user.
To Next Page
Loading...
Need help?
General
