Uponor UponorControl System User Manual

UPONOR CONTROL SYSTEM WIRED - INSTALLATION AND OPERATION MANUAL
5
2Preface
The Uponor Control System Wired installation manual describes
how to install and operate the components of the system.
Example applications and possible configurations of the system
are also included.
2.1 Safety instructions
Warnings used in this manual
The following symbols are used in the manual to indicate special
precautions when installing and operating any Uponor
equipment:
Safety measures
Conform to the following measures when installing and operating
any Uponor equipment:
• Read and follow the instructions in the installation and
operation manual.
• Installation must be performed by a competent person in
accordance with local regulations.
• It is prohibited to make changes or modifications not
specified in this manual.
• All power supply must be switched off before starting any
wiring work.
• Do not use water to clean Uponor components.
• Do not expose the Uponor components to flammable
vapours or gases.
• We cannot accept any responsibility for damage or
breakdown that can result from ignoring these instructions!
Power
Technical constraints
2.2 Disposal
The Uponor Control System consists of various recyclable
components. Uponor would be grateful if the components
(batteries, plastics, and electric or electronic parts) are sorted and
disposed of at a suitable recycling centre.
WARNING!
Risk of injury. Ignoring warnings can cause injury or
damage components.
CAUTION
Ignoring cautions can cause malfunctions.
WARNING!
The Uponor system uses 50 Hz, 230 V AC power. In
case of emergency, immediately disconnect the power.
CAUTION
To avoid interference, keep installation/data cables
away from power cables of more than 50 V.

Uponor UponorControl System Specifications

General

Brand	Uponor
Model	UponorControl System
Category	Temperature Controller
Language	English