UPONOR CONTROL SYSTEM WIRED - INSTALLATION AND OPERATION MANUAL
8
3.3.2 Thermostats
The following thermostats can be used in the system:
• Uponor Thermostat T-36 wired
• Uponor Thermostat T-38 wired
• Uponor Thermostat T-34 wired
• Uponor Thermostat T-35 wired
• Uponor Thermostat T-37 wired
• Uponor Thermostat T-33 Public wired
Uponor Thermostats T-36 and T-38 wired
Main characteristics:
• Temperature setpoint is adjusted with buttons
• Room temperature regulation with internal
sensor
• Optional floor sensor can be connected to the
thermostat
• Minimum or maximum floor temperature is adjusted with
buttons
• Programmable to switch between Comfort and ECO modes
• Can be set to auto-balancing mode
• Customer programmable ECO–comfort mode (T-38 only)
• Can be set to permanent override mode
• Hidden reset
• Powered by controller (no batteries)
Display shows:
• Setpoint temperature
• Room temperature
• Floor temperature
• Controller mode
• Balancing mode
• Comfort or ECO mode
• Heating/Cooling demand
• Holiday mode (T-38 only)
• Time and Date (T-38 only)
• Lock indication
• Standby mode
Uponor Thermostat T-34 wired
Main characteristics:
• Temperature setpoint is adjusted with a dial
• The dial is removed to set minimum and
maximum setpoints on the thermostat
• The comfort zone is indicated by the non-filled
(outlined) mark on the dial
• Powered by controller (no batteries)
• Flush mounted
Uponor Thermostats T-35 and T-37 wired
Main characteristics:
• Temperature setpoint is adjusted with a dial
• The dial is removed to set minimum and
maximum setpoints on the thermostat
• The 21 °C position is marked with a longer
mark on the dial
• Optional floor sensor can be connected to the thermostat (T-
37 only)
• Minimum or maximum floor temperature is adjusted with a
potentiometer behind the cover (T-37 only)
Uponor Thermostat T-33 Public wired
Thermostat T-33 is intended for public locations.
Main characteristics:
• Temperature setpoint is adjusted with an
internal potentiometer behind the cover
• Optional floor sensor can be connected to the
thermostat
• Minimum or maximum floor temperature is adjusted with a
potentiometer behind the cover
• The cover is removed to set minimum and maximum setpoints
on the thermostat
3.3.3 Timer
Uponor Timer I-36 can be connected to control the system.
Uponor Timer I-36 wired
Main characteristics:
• Two zones programming ECO–comfort mode
• Pre-recorded modifiable programs for working
days/weekend/week
• Date and time, with summer-winter change,
power failure proof
• Lock mode, standby mode
• Can be set to permanent override mode
• Programmable to switch between Comfort and ECO modes
• Hidden reset
• Dry contact input for forced ECO mode
• Powered by controller (no batteries)
Display shows:
• Room temperature in two zones
• Comfort or ECO mode
• Holiday mode
• Time and Date
• Lock indication
• Standby mode
To Next Page
