UPONOR CONTROL SYSTEM WIRED - INSTALLATION AND OPERATION MANUAL
32
9.16 Menu trees
9.16.1 Uponor Thermostat T-36
9.16.2 Uponor Thermostat T-38
The following sections show the menu trees for Uponor Thermostats T-36 and T-38
Run mode, see section 9.4, page 27
Regulation choices, see section, see section 9.9, page 29
Room sensor regulation, see section 9.9, page 29
Room sensor regulation with floor sensor limitation, see section 9.9, page 29
Maximum floor temperature limitation, see section 9.9, page 29
Minimum floor temperature limitation, see section 9.9, page 29
Remote sensor regulation, see section 9.9, page 29
Balancing mode, see section 9.10, page 30
Manual balancing, see section 9.10, page 30
Automatic balancing, see section 9.10, page 30
Economy mode, see section 9.11, page 30
Calibration, see section 9.13, page 30
Standby mode, see section 9.14, page 30
Run mode, see section 9.4, page 27
Run mode, see section 9.4, page 27
Clock settings, see section, see section 9.6, page 28
Year, see section, see section 9.6, page 28
Month, see section, see section 9.6, page 28
Day, see section, see section 9.6, page 28
Time, see section, see section 9.6, page 28
Summer-winter time, see section, see section 9.6, page 28
Programming mode, see section 9.7, page 28
Programming enable/disable, see section 9.7, page 28
Day group selection, see section 9.7, page 28
Holiday mode, see section 9.8, page 29
Regulation choices, see section, see section 9.9, page 29
Room sensor regulation, see section 9.9, page 29
Room sensor regulation with floor sensor limitation, see section 9.9, page 29
Maximum floor temperature limitation, see section 9.9, page 29
Minimum floor temperature limitation, see section 9.9, page 29
Remote sensor regulation, see section 9.9, page 29
Balancing mode, see section 9.10, page 30
Manual balancing, see section 9.10, page 30
Automatic balancing, see section 9.10, page 30
Comfort and economy mode temperatures, see section 9.12, page 30
Calibration, see section 9.13, page 30
Standby mode, see section 9.14, page 30
Run mode, see section 9.4, page 27