Vacon NXP - Page 4

4 • vacon shaft synchronization application
Tel. +358 (0)201 2121 • Fax +358 (0)201 212 205
7.2 Application specific variables in the monitor menu and fieldbus interface ........................... 86
8. Shaft Synchronization operation ...................................................................................... 87
8.1 Shaft Synchronization fieldbus interface................................................................................. 90
9. Appendices....................................................................................................................... 91
9.1 Closed loop parameters (ID’s 612 to 621)................................................................................ 91
9.1.1 Note on use of permanent magnet motors (“AC brushless” motors)..........................91
9.2 Parameters of motor thermal protection (ID’s 704 to 708):.................................................... 92
9.3 Parameters of stall protection (ID’s 709 to 712):..................................................................... 92
9.4 Fieldbus control parameters (ID’s 850 to 859) ........................................................................ 92
10. Shaft synchronization application specific fault codes..................................................... 93
11. COMMISSIONING of shaft synchronization application .................................................... 93