Vaisala Indigo300 - Installation; Opening Transmitter Cover; Figure 6 Opening Transmitter Cover

3. Installation
3.1 Opening transmitter cover
• 4-mm Allen key, provided
To avoid damaging the connector pins of the transmitter, pull the
transmitter cover straight o the base. Do not twist or bend. Be careful not to
drop the cover when it comes o.
CAUTION!
Figure 6 Opening transmitter cover
1. Loosen the screws on the transmitter cover.
2. Carefully open the transmitter cover part of the way from both sides, so that it is easier to
pull the cover o the base. The cover may be tight.
3. Pull the transmitter cover carefully straight o the base. Do not twist or bend. Be careful
not to drop the cover when it comes o.
4. When you reattach the transmitter cover, tighten the screws hand-tight using the 4-mm
Allen key (recommended tightening torque 3.6 Nm).
Indigo300 User Guide M212849EN-A
16