More information
‣
Connecting probes (page 27)
‣
Configuring analog outputs with Insight PC software (page 40)
‣
Configuring analog outputs with Indigo80 handheld indicator (page 43)
8.3 Restoring factory default settings with Insight
PC software
You can restore the transmitter back to its factory default settings using the Insight PC
software.
1. Connect the transmitter to the Insight software.
2. Select
> Factory default settings > Restore settings.
More information
‣
Connecting to Insight PC software (page 30)
8.4
Restoring factory default settings with
Indigo80 handheld indicator
You can restore the transmitter back to its factory default settings using the Indigo80
handheld indicator.
1. Connect the transmitter to the indicator.
2. Open the main menu by pressing
.
3. Select Devices. If you have more than one device connected to the indicator, make a
further selection between the devices.
In this case, select Indigo300.
4. Select Factory default settings > Restore settings > OK.
5. Confirm by selecting OK.
6. Exit the menu by pressing
or return to the main menu by pressing .
More information
‣
Connecting to Indigo80 handheld indicator (page 36)
Indigo300 User Guide M212849EN-A
58
To Next Page