3. Connect the M12 end of the cable to the desired port on the bottom of the indicator. You
can select the port freely based on your set of connected devices.
• Note the orientation of the cable connector when inserting it
• Hold the connector in place while turning its locking ring clockwise –
never twist the connector body!
4. Wait for the indicator to detect the transmitter.
When the indicator recognizes the connected transmitter, it shows a notification on the
display. On the transmitter display, the active connection symbol appears.
5.3
Selecting displayed parameters
You can use the Indigo80 handheld indicator to select which measurement parameters from
the probe connected to the transmitter are shown on the transmitter display.
1. Connect the transmitter to the indicator.
2. Open the main menu by pressing
.
3. Select Devices. If you have more than one device connected to the indicator, make a
further selection between the devices.
In this case, select Indigo300.
4. Select Settings.
5. Select Displayed parameters.
6. In Display parameter 1, 2, and/or 3, select the desired parameter.
The selectable parameters depend on the probe.
7. Exit the menu by pressing
or return to the main menu by pressing .
More information
‣
Transmitter display (page 11)
‣
Connecting to Indigo80 handheld indicator (page 36)
Indigo300 User Guide M212849EN-A
38
To Next Page
Loading...
