Vaisala Indigo300 - Figure 9 Mounting with Adapter Plate; Figure 10 Adapter Plate Mounting Dimensions

Figure 9 Mounting with adapter plate
134 [5.26]
169 [6.65]
5 [0.20]
96 [3.78]
183 [7.20]
mm [in]
20 [0.79]
25 [0.98]
12.5 [0.49]
Figure 10 Adapter plate mounting dimensions
1. If you intend to wire the transmitter through the back, lead the cables through the
opening in the adapter plate.
2. Attach the adapter plate to the mounting holes using 4 screws and 4 wall plugs.
3. Open the transmitter cover.
4. If you intend to wire the transmitter through the lead-through at the back:
a. Remove the center of the rubber lead-through.
b. Lead the cables to the inside of the transmitter enclosure before attaching it to the
adapter plate.
For more information on wiring through the back, see the wiring options.
Chapter 3 – Installation
19