Vaisala Indigo300 - Configuring Analog Outputs; Configuring Analog Outputs with Insight PC Software; Analog Output Configuration Overview; Figure 24 Analog Output Configuration Options Example in Insight

6. Configuring analog outputs
6.1 Configuring analog outputs with Insight PC
software
6.1.1 Analog output configuration overview
The transmitter has 3 analog outputs that can be configured with the Insight PC software.
Each output has the same set of configuration options in the analog output 1…3 menus under
the Configure device menu (Analog output 1 shown in example).
The available selections depend on the probe that is connected to the transmitter
(for example, CO
2
output parameter selection is only available for CO
2
probes).
Figure 24 Analog output configuration options example in Insight
The Analog output type selection in the General menu defines whether the outputs are used
for voltage or current output. When you change the output type, Insight reloads the
transmitter.
Indigo300 User Guide M212849EN-A
40