Vaisala Indigo300 - Connecting Probes; Figure 14 Indigo300 Grounding Using External Grounding Terminal

Figure 14 Indigo300 grounding using
external grounding terminal
1. Detach the grounding terminal screw and washer.
2. Place the cable lug of the grounding wire between the washer and the screw.
3. Tighten the screw to 3.6 Nm.
After grounding the transmitter, switch on the power supply input.
More information
‣
Power supply input terminals (page 22)
3.5
Connecting probes
Only connect compatible measurement devices to the transmitter.
Attempting to connect incompatible devices or cables can damage the
equipment. Refer to transmitter specifications for compatibility information.
CAUTION!
Chapter 3 – Installation
27